Category: Heating and Cooling Systems
Key Takeaways
How do you know if it’s a drain clog or sewer clog? Tell if one fixture or multiple are affected and if there is water backup,…
A tankless water heater that suddenly stops heating almost always traces back to one of five culprits: interrupted power or gas, water flow below the…
No hot water almost always traces back to one of four failures: a tripped breaker, a dead thermostat, a burned-out heating element, or an interrupted…
Key Takeaways
Constant sump pump running is typically due to mechanical problems, improper sizing, high groundwater, or discharge…
A persistent sewer smell in your house almost always traces back to a broken water seal somewhere in the plumbing – most often a dried-out P-trap, a…
A main sewer line clog is a blockage in the single pipe that carries wastewater from your whole home out to the municipal sewer, and it usually…
A sump pump alarm going off means the float switch or sensor has detected water rising above the safe level in your pit. The most common triggers are…
Hydro jetting clears heavy grease, tree roots, and mineral scale with 1,500 to 4,000 PSI water, while drain snaking uses a steel cable to break up…
A Bradford White water heater typically lasts 8 to 12 years, though tankless models can reach 20 with proper care. In Parker and the south Denver…
Multiple fixtures draining slowly at the same time almost always signals a systemic problem deep in your home’s plumbing rather than a simple local…